Tweet
I got a great link that explains everything I need, however there is one problem that remains. My amp doesn't have a standby switch.
Now in the normal procedure, I'd take the tubes off, turn the amp to standby and make the appropriate reads, THEN plug in the tubes and turn the amp on.
How do I get doing this with an amp without standby?
I got a little probe today that i just built that connected a 1ohm resistor across pin 8 and the ground, with reading meters, and those ****ers don't connect to my voltmeter [img]/images/graemlins/laugh.gif[/img] So I'll have to use the pins on the voltmeter on the pins of the wires from the probe. More inaccuracies... Ah well. I'll probably give it a try tomorrow.
Now in the normal procedure, I'd take the tubes off, turn the amp to standby and make the appropriate reads, THEN plug in the tubes and turn the amp on.
How do I get doing this with an amp without standby?
I got a little probe today that i just built that connected a 1ohm resistor across pin 8 and the ground, with reading meters, and those ****ers don't connect to my voltmeter [img]/images/graemlins/laugh.gif[/img] So I'll have to use the pins on the voltmeter on the pins of the wires from the probe. More inaccuracies... Ah well. I'll probably give it a try tomorrow.