Questions on Speaker impedance...or can i

[Robert Burns]

do this with my incoming VHT 2/90/2 rack amp.

Right now, im running 2) Crate G212S 2/12" cabs.. PLUS my 4/12
Kustom cab out of my SS Peavey CS200 stereo amp.
I have one 2/12" Crate and the 4/12" Kustom on the left channel (2 lefts out, and 2 rights on the back of the Peavey)
And i just have the one Crate 2/12" for the right channel. These coming from the Boss GT-8

The 4/12 cab is 8 ohms.. both the Crates are sectable 4/ or 16 ohms
mono, or 8 ohms (stereo) Seems to be fine.. but "Fine" is just a Solid
State $200 amp! I dont want to create a problem with the VHT/
So can i always do any combination, as long as the ohms of the cabs
are equal or more than the rating of the output of the amp?

[markD]

hmmm, you are better off putting the 2 crates on one side, setting them at 16 ohms each, then putting the poweramp on 8 ohms for that side, then putting the kustom on the other side set at 8 ohms. that way you are running the amp with a consistent load - 8 ohms per side.

[Robert Burns]

hmmm, you are better off putting the 2 crates on one side, setting them at 16 ohms each, then putting the poweramp on 8 ohms for that side, then putting the kustom on the other side set at 8 ohms. that way you are running the amp with a consistent load - 8 ohms per side.

****************** Thanks! Will try that (i just like what
the 4/12 adds for bottom end. I can hear it, over the 2/12 cabs