If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
So I modified my SL+ (superlead) module with a switchable low end (tightens it up) and also a JCM800 tone stack that's switchable. Recorded a few clips, whattaya think?
These are clips of the amp by themselves, playing basically the same riff. I did NOT change any settings on the module between 'no mods' and 'modded' except for:
Changing the bass from stock to the tightest setting
Changing the tone stack from stock to JCM800
Gain, volume, eq on the module and volume of the amp were kept exactly the same, as were mic and recording settings.
Here are the two in a mix - same settings/criteria as above. I did use a few mastering tools and reverb to make them sit in the mix, and I thought I used the same amount on both tracks, but the modded sounds a lot wetter.
Very cool! (But you need an ADA MP-1 to finish it out! :ROTF:
I liked #2..and #4. #4 started off a bit dull in clarity,
but then got much higher and near perfect towards the end?
To my crappy ears anyway. Great playing my brutha!
Comment