If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
It's standard on anything with a 1 11/16" nut width and binding. An R3 or R4 on would work on models without binding, but I'm not sure which they use on those. Someone here should know.
They use the R3 on damned near everything, from what I can tell. The Pro Mods and all of the custom shop Charvels with a 1 11/16 nut I've seen, binding or not, use an R3.
The best way to tell is to remove the existing nut and see what size it has stamped on the bottom, for sure.
Comment