Tweet
This is not for everybody cause its basically one guy building these.
I have been working for 3 days on specs and just about have everything figured out but what nut I want (R4 or R5).
Looks familiar doesn't it? The color I am getting is in the pic below. Gold hardware. 24 frets - I want that Humbucker tone in the neck position. He can make the neck joint and neck heel line up in the same spot as if it were 27 frets.
Plus I spec'd out my own neck proportions. Alder Body, 1/8" Flamed Maple Top, Maple Neck, Birds Eye Maple Fingerboard with no inlays, Schaller Trem, Coil splitter, 2 Hums.
Neck: .80" thick at first fret, .87" at 12th fret (a bit skinnier than PC1). Trying to get a nice wide board - minimum R4 nut wide spacing. Might go R5.
I have been working for 3 days on specs and just about have everything figured out but what nut I want (R4 or R5).
Looks familiar doesn't it? The color I am getting is in the pic below. Gold hardware. 24 frets - I want that Humbucker tone in the neck position. He can make the neck joint and neck heel line up in the same spot as if it were 27 frets.
Plus I spec'd out my own neck proportions. Alder Body, 1/8" Flamed Maple Top, Maple Neck, Birds Eye Maple Fingerboard with no inlays, Schaller Trem, Coil splitter, 2 Hums.
Neck: .80" thick at first fret, .87" at 12th fret (a bit skinnier than PC1). Trying to get a nice wide board - minimum R4 nut wide spacing. Might go R5.
Comment