If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
birdseye all the way. just make sure you select best option to assure you get enough of it in there flame'd maple necks are ok but just not as obvious as a premium grade birdseye neck imho. Also get one piece construction. If you not getting a different board dunno why you'd wanna glue a fretboard on any neck unless it was ebony or rosewood.
birdseye all the way. just make sure you select best option to assure you get enough of it in there flame'd maple necks are ok but just not as obvious as a premium grade birdseye neck imho. Also get one piece construction. If you not getting a different board dunno why you'd wanna glue a fretboard on any neck unless it was ebony or rosewood.
You should put a black pickguard on it. That'll make that awsome quilt stand out so much more.
My Toys:
'94 Dinky Rev. Purple Burst Flame Top
'94 Dinky Rev. Cherry Burst Flame Top
'94 Dinky Rev. Purple Burst Quilt Top
'94 Dinky HX in Black
'12 ESP Mii NTB in Black
i'd highly suggest putting carbon fiber rods in the neck if you decide to get a highly figured neck (especially if there's not going to be a hard finish on it). either way, at least make sure that you're getting quartersawn maple.
Comment