If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Ummmm...neither of those cars is a C4 (4th gen). or am I missing something here? [img]/images/graemlins/laugh.gif[/img]
[/ QUOTE ]
Well, I now own the bottom one. The top one was my first car and yes, they're both C3s [img]/images/graemlins/headbang.gif[/img] Here's both my current cars...I was talking about selling the '87 C4 below. [img]/images/graemlins/wink.gif[/img]
Thanks! it was a sweet ride. In the 1/4 or 400m to you [img]/images/graemlins/wink.gif[/img] it ran [email protected] mph(200 km/h) just as it drove on the street. I can't tell you how many times it showed the tail end to people thinking it was a stock lt-1 clone [img]/images/graemlins/wink.gif[/img] Though the license plate should have been enough warning. It was LPE-383
12.02 @ 118.6 was my best time as it was in that picture(kumho's 275.35.18(i think) 60' was a 2.00. On the bfg 275's best 60' was 1.73(never hooked) It pulled like a freight train on top! This was done at Englishtown N.J. Nov 2003. I sold the car in July of 2004. My 2004 Z06 below replaced it.
I tried drag radials several times.(BFG) Burnouts from a little chirp, to smoke coming in the car. Didn't help! Almost 500 foot pounds of torque isn't easy on a hard launch. The 60' on bfg dr's was 1.73, a 2.00 was my best on streets.
My LS6 doesn't quite have the feel of my former LPE-383, but man does it rev! The 383 was done around 5800(I went to 6 sometimes) the LS6 pulls CLEAN to 6600! I love how it sounds. Less torquey, but TONS of top end! From a production 350 aluminum block, I think GM did well with the z06 engine(That new LS7 is nutso! 505 hp stock!)
Comment