If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Does anybody have any info on this??? Never knew Jackson made a USA bolty...looks more like the newer Charvels you see on ebay from time to time with a different logo.
Looks like a typical Ontario product to me. "made in USA" logo is in the wrong place for a San Dimas era. And no Jackson didn;t exsist until the first Rhoads in '80 It was Charvel up till that point. But if i'm wrong im sure someone will correct me
Gil
I always doubted the notion they made necks only as needed. I'm pretty sure they'd make a bunch of necks and put them in a box, just so they'd have some on-hand if/when the planer or bandsaws went down. That being the case, it shouldn't be too hard to imagine that a neck made in 1985 was not used until 1986.
I want to depart this world the same way I arrived; screaming and covered in someone else's blood
The most human thing we can do is comfort the afflicted and afflict the comfortable.
I'm not getting involved because I just don't know what it is. I know it's not a dinky body,(2b) it is a 3-4b body with the large cover, but that's all I know. I thought all that old USA stuff had normal p- config, that thing is - reverse-p
and the switch is on the wrong side???
maybe someone put a plate and neck on it long ago???
Comment