Installing a Sustainiac with EMG solderless setup

[JelloStorm]

Is this possible? I currently have a DK2T with EMG actives using the EMG solderless wiring kit. I'd like to replace the bridge with a Sustainiac and then install two little toggle switches for on / off and the harmonic setting (i think it is).

[Radiohead]

Check out Sustainiac.com. You need to put the Sustainiac in the Neck PicK UP, not Bridge and you need to reverse the bridge wires on the switch. The guys at Sustainiac were great to deal with and will answer any questions.

[JelloStorm]

Yeah I meant neck position. I'm still on the fence about the EMG though, so I'm going to give them a call sometime this week. I just put a bid on a Duncan PATB-2 so I might just use that. Switching to a Type O Negative type setup