Magnet Swapping in a JB

[groverj3]

A 1 meg pot will increase the jb's output and its high end u newsroom go the other way to a 250k pot.

Why would I go to a 250k volume? I'm trying to increase the output and tightness of the bass response, not decrease and muddy up the tone. Plus, I'm still not going to be running a 500k tone, the 300k should have more brightness than the stock 250k, but not the icepick high end of a 500k with a JB. Hopefully anyway. If i don't like it I can just put it back together the stock way, I have lots of 500k controls laying around.

As far as swapping magnets vs. soldering. It's not that hard, unscrew the back plate, pull out the old magnet, orient and install the new magnet. Put back plate back on, and you're done!

Anyway, once I get around to whatever it is I end up doing I'll post about it.