If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I need to drill a few holes in a trans finish Soloist to make it GK ready (I already have one guitar with that awkward GK3 wart and don't want another). Will drilling holes through a maple veneer cause issues similar to Joel's doughnut Warrior?
Fuck ebay, fuck paypal
"Finger on the trigger, back against the wall. Counting rounds and voices, not enough to kill them all" (Ihsahn).
Comment