Tweet
I am currently drawing out an effects switching system for my rig, and plan to order the parts and start building soon.
I would like to run my plans by a couple of you here, since I know there are some here who have knowledge about electronics.
I have finished about 3/4ths of an Electronics Technology associates degree at Indiana State Univ. and I feel my design will work, but I'm not exactly sure.
PM me if you would like to see what I've sketched out so far,
It is based on momentary pushbutton footswitches into CMOS octal latches, then a buttload of diodes into Opto-isolators that will open up the different signal chains of the pedals.
NandrewNoah [img]/images/graemlins/headbang.gif[/img]
I would like to run my plans by a couple of you here, since I know there are some here who have knowledge about electronics.
I have finished about 3/4ths of an Electronics Technology associates degree at Indiana State Univ. and I feel my design will work, but I'm not exactly sure.
PM me if you would like to see what I've sketched out so far,
It is based on momentary pushbutton footswitches into CMOS octal latches, then a buttload of diodes into Opto-isolators that will open up the different signal chains of the pedals.
NandrewNoah [img]/images/graemlins/headbang.gif[/img]