If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
How much did that run you? I ended up blocking my trem with a shim of aluminum, topped with a piece of Buna-n rubber. I don't get any of the clunking that many complain, thanks to the rubber, cushioning the impact.
Yup, that would be it. Missing a few parts, though. How is it, operationally, installed? I mean, as it's not mounted like it was in the picture provided, is there any rubbing or interference of any sort?
Yup, that would be it. Missing a few parts, though. How is it, operationally, installed? I mean, as it's not mounted like it was in the picture provided, is there any rubbing or interference of any sort?
LOL, you'd never know there were parts missing. It works perfectly as is. It just requires one screw to install. There is enough room under the trem springs, that it does not rub or interfere with them at all.
It works great too. Tuning is very, very stable. I have the adjustment nuts tightened all the way up, but if you loosen them up, you can still pull back on the trem, so I guess it works as either a stabilizer or a block.
Comment