Changing Trem Posts

[Soap]

I've replaced these bushings quite a few times. I just get some 100-150 grit sandpaper, roll it up so that it will fit in the hole and sand it until the bushing will go about 3/4ths the way in. Then I just tap it in. Works perfectly and have never had any problems.

Bingo we have have a winner.
Simplicity at its best, kudos.
The better answer by far and no drill required. No chance of over drilling or not holding the drill steady and straight and screwing it up and making it much potentially worse.

[UFORocks]

I've replaced these bushings quite a few times. I just get some 100-150 grit sandpaper, roll it up so that it will fit in the hole and sand it until the bushing will go about 3/4ths the way in. Then I just tap it in. Works perfectly and have never had any problems.

Thats a damn good idea!

[Sunbane]

Thats a damn good idea!

+1
I will do that the next time I need to change posts!

[straycat]

Great idea thanks.