Floyd Rose Tunning Problem

[GuitarWizard]

I recently purchased a guitar with a Floyd on it and changed the string guage from .008 to .010 and did the set up ( adjusted the spring tension, string height etc. ) as soon as I use the bar the guitar goes out of tune ( yes its locked down ) . I have the bridge set parallel with the body as I do on my other guitars, is this wrong? My other Floyd equiped guitars have 3 springs this one only has 2 could that be the problem? Any ideas? Some help would be appriciated .
Thanks
Randy

[rjohnstone]

Add a 3rd spring.
Also, make sure the strings have been properly stretched (broken in). I usually do a few good dives then pull ups to get the strings in their "happy" place. Then retune and lock 'em down. You should be good to go.

[Bengal65]

Add a 3rd spring.
Also, make sure the strings have been properly stretched (broken in). I usually do a few good dives then pull ups to get the strings in their "happy" place. Then retune and lock 'em down. You should be good to go.

+1, This will work for you!

[Dreamland_Rebel]

+1
and you need to stretch the hell out of the strings within the first 15-20 minutes of them being on the guitar at tension. i like to stretch them with the locking nuts off and retune and stretch and retune again and agian unitll the whole thing stays close to tune after a round of stretching.

then i lock down and stretch and retune. good to go.