As fanboy as this sounds, I have an RR with a single pickup (emg hz-h4) and single volume.
I have a JE-1000 clone (MM-04), and the jackson wiring diagram is shitty (to say the last).
I'm no n00b when it comes to electronics, as i've built countless stereos, scanners, guitar electronics, and rewired amp boards. However, I CANNOT figure out the JE-1000.
They have a built-in volume pot (it's PLASTIC in the MM-04, but good) and such. Anyway, it was one lead that just says (connect to pickup). Long story short..
I need a COMPLETE wiring diagram/instructions on how to wire this up. I've tried every combination i can think of which either results in splitting the pickup coils (running in single coil)or grounding issues (when I turn my amp on it's instant feedback).
So. HELP!
I have a JE-1000 clone (MM-04), and the jackson wiring diagram is shitty (to say the last).
I'm no n00b when it comes to electronics, as i've built countless stereos, scanners, guitar electronics, and rewired amp boards. However, I CANNOT figure out the JE-1000.
They have a built-in volume pot (it's PLASTIC in the MM-04, but good) and such. Anyway, it was one lead that just says (connect to pickup). Long story short..
I need a COMPLETE wiring diagram/instructions on how to wire this up. I've tried every combination i can think of which either results in splitting the pickup coils (running in single coil)or grounding issues (when I turn my amp on it's instant feedback).
So. HELP!
Comment