Installed EMG's today, everything went well, except for I accidently reversed the toggle switch. (It was my first time installing pickups or using a soldering iron, so I was pretty happy).
BUT
I am having two problems, first this happened. I don't know how that one pot is so much farther out than the others. Very wierd. Do I just need new knobs? I don't think they go all the way down anyways.
Second is, I need to adjust the bridge pickup higher than that springs currently allow it to raise. Can I just cut the springs a bit so I have more room to raise the pickup?
BUT
I am having two problems, first this happened. I don't know how that one pot is so much farther out than the others. Very wierd. Do I just need new knobs? I don't think they go all the way down anyways.
Second is, I need to adjust the bridge pickup higher than that springs currently allow it to raise. Can I just cut the springs a bit so I have more room to raise the pickup?
Comment