JE-1200 H/H wiring help?

[sl2lover]

My tekky is gonna attempt to wire my axe with a JE-1200 circuit in the H/H config, with an EMG 60 neck/EMG 81 bridge. Anyone have any experience trying to wire a similar configuration? Note that I have given him a cpl schematics from the audiozone site etc... Any help would be much appreciated so to make it easier on him. Thanks guys!

[sl2lover]

Anybody chime in? Can you wire the JE-1200 to just one tone knob config, or do you need two??

[dg]

You don't have to have a tone control, but you'll need the midboost level control pot, so you can get away with just the onboard volume pot and that.

[sl2lover]

I thought the mid boost was full time, and the the onboard pot was the volume?

[dg]

The onboard pot is the volume. There is another 50k pot used for the midboost level control. On C/J guitars with the boost installed, like a Model 6, it's set up with 3 pots: vol, tone, and midboost control.

You can see all 3 in this diagram, midboost on the far right:

http://audiozone.dk/cm/displayimage.php?pid=491&fullsize=1

Quite a few people think they have 2 tone controls when they get a used guitar with the midboost, but they don't.

[Slik_Karl]

I never saw that config? I have a Jackson 1988 limited edition. It has one volume pot on the board and a 5 way switch. S/H config. Am I to understand that the boost has never been activated in my guitar? Just curious
Sorry I messed up I have the JE-1000, my bad

[sl2lover]

The onboard pot is the volume. There is another 50k pot used for the midboost level control. On C/J guitars with the boost installed, like a Model 6, it's set up with 3 pots: vol, tone, and midboost control.

You can see all 3 in this diagram, midboost on the far right:

http://audiozone.dk/cm/displayimage.php?pid=491&fullsize=1

Quite a few people think they have 2 tone controls when they get a used guitar with the midboost, but they don't.

Great thanks a ton for the help!!!!